Description
- Seagate ST41600ND
- Capacity 1.4 GB formatted, 1.6 GB unformatted
- This disk has actually been used on the GTI system as VOL-1-13, ONLINE-SPEIL-2, with SCSI ID 0
- Main PCB size 193 x 140 mm
- Motor PCB size 78 x 64 mm
- Release date xx. xxx. xxxx
Chipset
LEDs
Straps
- Strap block J1, rear view:
- Spinup delay (10 sec * ID), ND default open
- Motor start option enable, ND default open
- Parity check disable, ND default open
- Sweep cycle enable, ND default closed
- Strap block J2, rear view:
- SCSI ID4 - ND default open
- SCSI ID2 - ND default open
- SCSI ID1 - ND default open
SCSI identification
- Write protect option enable, ND default open
- Master off/Slave on - spindel sync., ND default open
- Strap block J3, rear view:
- Spindle sync 4, ND default open
- Spindle sync 2, ND default open
- Spindle sync 1, ND default open
- Strap block TP
4 | 3 | Initiator supplies power over the SCSI bus for terminators. Drive supplies no terminator power. ND default closed. |
2 | 1 |
4 | 3 | Drive supplies power for its own terminator resistors but not to SCSI bus. ND default open. |
2 | 1 |
4 | 3 | Drive supplies power for external terminator at end of the daisy chain. Terminator resistors must be removed. This option is recommended only for last drive on daisy-chain. (This option only on Single-Ended drives). ND default open. |
2 | 1 |
Switches
Connectors
|
Top view
Bottom view
Front view
Rear view
Jumpers locations
Component side, main PCB
Solder side, main PCB
Component side, motor PCB
Solder side, motor PCB
|